EasyManuals Logo

Siemens CPU 414-5H User Manual

Siemens CPU 414-5H
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Description of the device
4
4.1 Components of the product
The following components are supplied with a synchronization module:
Synchronization module
Product information
Unpacking and checking
WARNING
Do not use any parts that show evidence of damage
If you use damaged parts, there is no guarantee that the device will function according to the
specification.
If you use damaged parts, this can lead to the following problems:
Injury to persons
Loss of the approvals
Violation of the EMC regulations
Damage to the device and other components
Use only undamaged parts.
1. Make sure that the package is complete.
2. Check all the parts for transport damage.
4.2 Synchronization modules for S7–400H
Function of the synchronization modules
Synchronization modules are used for communication between two redundant S7-400H CPUs.
You require two synchronization modules per CPU, connected in pairs by fiber-optic cable.
Note
You must use 4 synchronization modules of the same type in an H-system.
The system supports hot-swapping of synchronization modules, and so allows you to influence
the repair response of the fault-tolerant systems and to control the failure of the redundant
connection without stopping the plant.
Synchronization modules for S7-400H
Equipment Manual, 04/2020, A5E50072434-AA 11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens CPU 414-5H and is the answer not in the manual?

Siemens CPU 414-5H Specifications

General IconGeneral
BrandSiemens
ModelCPU 414-5H
CategoryControl Unit
LanguageEnglish

Related product manuals