Siemens CT636LE 1 Series User Manual

33
en
Initial use
Button E
Press button E to open the selection
of service programmes. Run the desired
programme as described in the section
“Service programmes”�
Button B
Press button B to open the selection
of “Personalised beverage preparation”�
Personal settings for co󰀨ee drinks can
be saved and called up (see the section
“ Personalised drinks”)�
Button G
Press button G after selecting a drink to
prepare two cups simultaneously (see the
section “Two cups at once”)�
F
Press A, E, B
or G again to exit the respective
menu�
Button C
Press C to either begin preparing
a drink or launch a service programme�
Press C again while the drink
is being prepared to prematurely halt
dispensing�
Rotary selector
Turn the rotary selector to navigate in the
display or to change parameters�
Display (Touchscreen)
Information is shown on the display, or
settings can be made by touching the
touchscreen (see the section “Display”)�
Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use co󰀨ee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit�
A
Before the appliance can be switched
on and used, it must be assembled
and connected according to the
enclosed assembly instructions�
Setting up the appliance
■ Remove any protective plastic lm.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
■ Take hold of the appliance door by the
recessed grip and open�
■ Remove the water tank, rinse it and ll it
with fresh water up to the “max” mark�
■ Replace the water tank and click into
place�
■ Remove the bean container, ll with
co󰀨ee beans and replace.
■ Set the mains switch to I and close the
appliance door�
The appliance heats up and is rinsed�
The display is activated�
“Select language” appears�
■ Turn the rotary selector to select the
desired language and touch [ Continue ]
in the display�
“Set water hardness” appears�
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level 4�
If a water softener is installed in the
house, please set the water hard-
ness to level 3. You can also check
the water hardness by asking your
local water supplier�
■ Use the enclosed test strip to determine
the water hardness. Briey dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
■ Turn the rotary selector to set the water
hardness determined�

Siemens CT636LE 1 Series Specifications

General

Brand	Siemens
Model	CT636LE 1 Series
Category	Coffee Maker
Language	English