en HomeConnect
58
13.2 Setting up HomeCon-
nect
Requirements
¡ The HomeConnectapp has been
installed on your mobile device.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
1. Open the HomeConnect app and
scan the following QR code.
2. Follow the instructions in the
HomeConnect app.
13.3 HomeConnect settings
Adapt HomeConnect to your needs.
You can find the HomeConnect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
HomeConnect has been set up and
whether the appliance is connected
to your home network.
Overview of the Home Connect settings
You can find an overview of the HomeConnect settings and network settings
here.
Basic setting Selection Description
HomeConnect
assistant
Start
Disconnect
Add mobile device.
Disconnect appliance from network.
WiFi On
Off
Switch off the wireless module during
long absences or to save energy.
Note:In networked standby mode
your appliance requires max. 2W.
Remote start On
Off
Switch remote start on the appliance
on and off.
Note:With the HomeConnect app
only switch-off is possible.
Software update - Note:This setting is only available
with a software update.
Note:When "WiFi" and remote start
are switched on,
and appear on
the display.
13.4 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
To Next Page
Loading...
Need help?
General
