18
en
Preparations for installation
Shut off the water supply before connect- ■
ing the appliance. The electrical connection
must be disconnected from the mains supply.
Unscrew the fuse or switch off the circuit
breaker.
For all appliances
A clearance of about 60 mm on all sides of the
appliance is required for installation.
Observe the technical appliance data.
■
Break out the installation bracket from the rear ■
of the appliance (A).
Only for DE04101 and DE10104
Break out ■one of the side knock-outs (B1) pro-
vided for an incoming electrical supply cable.
Feed the desired length of the incoming electri-
■
cal supply cable downwards through the knock-
out (B2).
Important:
■ Connect the unit only to a mains
socket with protective contact that is installed
according to regulations. Do not use an exten-
sion cord. If necessary, equip the unit with a
longer cord.
To Next Page
Loading...
