4
deen
Before using
for the rst time
General
Fill the water tank with fresh, uncarbonated
water only, and preferably use only beans
for fully automatic coffee and espresso
machines. Do not use coffee beans that
have been glazed, caramelized or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If a value other than water hardness 4 is
displayed, change the setting on the
appliance accordingly after switching on
(see “Menu settings Water hardness”).
Switching on the appliance
Place the fully automatic espresso
machine on a at surface that can take its
weight.
Note: The appliance has four runners under
its base and can be moved sideways in an
arc to make operation and positioning
easier.
Pull the power cord out of the storage
compartment 31 and plug in. Adjust the
length of the cable by pushing it back in
or pulling it out. The easiest way to do
this is to place the appliance so that its
back is ush with the edge of the counter
and either pull the cable downward or
push it upward.
Lift the lid of the water tank 12.
Remove and rinse the water tank 11 and
ll it with fresh cold water.
Do not ll above the “max” mark.
Replace the water tank 11 and push it
rmly downward into place.
Close the lid of the water tank 12 again.
Fill the bean container 15 with coffee
beans.
●
●
●
●
●
●
●
Press the power switch 1 O / I. The
start
button 8 lights up and the different
languages appear in the display 5.
Use the buttons 4
< and > to select the
language in which you want the display 5
texts to appear.
Language
engLish
start
Pycckий
nederLands
The selected language is highlighted by a
frame. The following languages can be
selected:
engLish
P
ycckий
n
ederLands
F
rançais
i
taLiano
s
venska
e
sPañoL
P
oLski
● Press the
start
button 8. The language
you selected is saved and the
a button 2
lights up.
●
●
To Next Page
Loading...
