Siemens EQ.7 - Auto Off After; Water Filter; Factory Settings

11
deen
j 3 sec. + >
auto oFF aFter
Turn the knob 6 to enter the time span
after which the appliance should
automatically switch to “energy saving
mode” following drink preparation.
A time between 5 minutes and 8 hours can
be set.
j 3 sec. + >
Water FiLter
Before a new water lter is used, it must be
rinsed.
To do this, place the water lter rmly into
the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the “max” mark.
Turn the knob 6 to select start and
press the start button 8.
● PLace 0.5 L container under miLk
Frother  start
Place a container with a capacity of 0.5
litres under the milk frother 10.
Press the start button 8. Water will now
ow through the lter to rinse it.
Next, empty the container. The appliance
is ready to use once more.
Note: Rinsing the lter simultaneously
activates the setting for the “change lter”
display.
You can nd detailed information about the
water lter in the enclosed lter instructions.
●
●
●
●
●
●
The lter is no longer effective when the
change FiLter display appears, or at the
latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement lters can be obtained from
retailers (TZ70003) or from customer
service (467873). If no new lter is used,
turn the Water FiLter setting to no.
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
lter should be rinsed before the appliance
is used again. To do this, simply dispense a
cup of hot water.
j 3 sec. + >
contrast
The display 5 contrast can be set from –20
to +20. The factory setting is +0.
Enter the required setting with the knob 6.
j 3 sec. + >
Factory settings
You can cancel your own settings and
reactivate the factory settings.
To activate the factory settings, press the
start button 8.
Note: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched off
fully.
Hold down the < and > buttons 4 and
the on/off switch 1 O / I at the same time
for at least 5 seconds. Press the start
button 8 The factory settings are now
reactivated.
●
●
●