EasyManua.ls Logo

Siemens EQ.7 - CalcnClean

Siemens EQ.7
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
deen
Empty drip tray 27 and replace them.
The appliance is ready for use again.
Calc‘n‘Clean
Calc‘n‘Clean combines the separate
functions of descaling and cleaning. If both
programs are due to be run soon, the
espresso machine automatically suggests
this service program.
esPresso Ë Í
service - caLcn‘cLean
i - button 3 sec.
The
start
button 8 ashes while the different
Calc‘n‘Clean processes are running. The
gures on the top right indicate the progress
of the program.
Hold the j button 7 down for at least 3
seconds.
caLcncLean
start
Press the
start
button 8; the display will
guide you through the program.
emPty driP tray
rePLace driP tray
Empty drip tray 27 and replace them.
Swivel the coffee outlet 9 to the right until
it clicks into place.
Place a container with a capacity of at
least 1 litre under the milk frother 10.
Press the
start
button. The appliance
rinses twice.
cLeaning
o
Pen draWer
Open the drawer 20 by pressing.
insert siemens cLeaning tabLet and
cLose draWer
Drop a Siemens cleaning tablet in the
drawer 20 and close.
Note: If the water lter is activated, the
display 5 will prompt you to remove the lter
and press the
start
button 8 again.
remove FiLter
start
add 0.5 L Water and descaLer
start
Pour lukewarm water into the empty
water tank 11 up to the “0.5” litre mark
and dissolve 2 Siemens descaling tablets
in it.
Press the
start
button 8. The descaling
program now runs for about 20 minutes.
descaLing
not enough descaLing
FLuid. reFiLL FLuid
Note: If there is not enough descaling
solution in the water tank 11, the
corresponding prompt is displayed. Pour in
descaling solution and press
start
8 again.
cLean and reFiLL Water tank
start
Rinse the water tank 11 and rell it with
fresh water up to the “max” mark.
Press the
start
button 8. The descaling
program now runs for about 1 minute
more, followed by the cleaning program
for about 7 minutes, and rinses the
appliance.
descaLing
cLeaning
emPty driP tray
r
ePLace driP tray
Empty drip tray 27 and replace them.
The appliance has completed descaling and
cleaning and is ready for use again.

Table of Contents

Other manuals for Siemens EQ.7

Related product manuals