EasyManuals Logo

Siemens EQ.700 classic TP Series User Manual

Siemens EQ.700 classic TP Series
Go to English
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
en Before using for the first time
44
descaling. You can use the enclosed
test strip to check the water hardness
or ask your local water company.
1. Briefly dip the test strip in fresh tap
water.
2. Allow the water to drip off the test
strip.
3. Read the water hardness off the
test strip after 1minute.
The table shows allocation of the
levels to the different degrees of
water hardness:
Level German
degrees in
°dH
Total hard-
ness in mmol/
l
1 1-7 0.18-1.25
2 8-14 1.42-2.49
3 15-21 2.67-3.74
4
1
22-30 3.92-5.34
1
Factory setting
Note:If a water softening system is
installed in your house, you can se-
lect "Softening device".
Tip:You can change the settings at
any time.
→"Basic settings", Page50
6.3 Performing initial start-up
After connecting the appliance to the
power supply, configure the settings
for initial start-up. Initial start-up only
appears when switching on for the
first time.
1. Press to switch the appliance
on.
2. Follow the instructions on the dis-
play.
a The display will guide you through
the programme.
Notes
¡ To set up Home Connect, refer to
the documents on Home Connect
supplied with the appliance.
¡ If "Demo mode" is selected, only
the display screens will work. You
can not dispense a beverage or
run a programme.
6.4 General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Notes
¡ The appliance has been pro-
grammed at the factory with stand-
ard settings for optimum operation.
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can adjust the grinding level
when the grinder is running.
→"Adjusting the grinding level",
Page46
¡ If you do not perform any actions
on the appliance for a certain
period, it will switch off automatic-
ally. You can change the duration
in the basic settings. →Page50
¡ During operation water droplets
may form at the ventilation slits
and on the lid of the tablet com-
partment.
¡ For technical reasons steam can
escape from the appliance.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens EQ.700 classic TP Series and is the answer not in the manual?

Siemens EQ.700 classic TP Series Specifications

General IconGeneral
Milk FrotherYes
Pump Pressure19 bar
Power1500 W
One-Touch PreparationYes
Coffee Strength SettingsYes
Adjustable Grinding DegreeYes
User ProfilesYes
ColorBlack
Power Consumption1500 W
Voltage220-240 V
Frequency50-60 Hz
ProgrammableYes
Water Tank Capacity1.7 liters
GrinderCeramic
Milk SystemIntegrated Milk System with autoMilk Clean

Related product manuals