en Grinder
46
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶
Never touch the milk system when
it is hot.
▶
Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk hose with the suction
pipe is connected to the milk sys-
tem.
¡ The suction pipe is immersed in
milk.
1. Place a glass underneath the
beverage outlet.
2. Press "Classics".
3. Select and press the beverage
symbol for latte macchiato.
‒ To change the strength, press .
‒ To change the per-cup quantity,
press .
‒ To change the milk ratio, press
.
4. Press "Start" and wait until the pro-
cess is complete.
‒ To completely stop dispensing
the beverage, press "Stop".
‒ To only stop the current dis-
pensing step, press "Skip".
After preparing the beverage, the
milk system will automatically
clean itself with a short jet of
steam.
Notes
¡ If you do not change any settings
for approx. 30seconds, the appli-
ance will exit settings mode.
¡ The appliance saves the settings
automatically.
Tip:You can also pre-heat cups be-
fore dispensing using hot water or
the cup heater
1
.
7.5 Dispensing two cups at
once
Depending on the appliance model,
you can make two cups at the same
time for certain beverages.
Note:If the "doubleShot" or
"tripleShot" function is active, the
function for dispensing two cups at
once is not possible.
1. Press the symbol for your desired
drink.
2. Press .
a The setting is shown on the dis-
play.
3. Place two cups on the left and
right underneath the beverage out-
let.
4. Press "Start".
The beverage is prepared in 2
steps. The beans are ground in 2
grinding operations.
a The beverage is brewed and then
runs into the cup.
5. Wait until the process is complete.
Grinder
8 Grinder
Grinder
Your appliance has an adjustable
grinder, which you can use to cus-
tomise the grinding level of your cof-
fee beans.
8.1 Adjusting the grinding
level
Set the desired grinding level while
the coffee beans are being ground.
WARNING
Risk of injury!
The grinder rotates.
▶
Never reach into the grinder.
1
Depending on the appliance specifications
To Next Page
Loading...
Need help?
General
