en first time
16
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can adjust the grinding level
when the grinder is running.
→"Adjusting the grinding level",
Page20
¡ During operation water droplets
may form at the ventilation slits.
¡ If you do not perform any actions
on the appliance for a certain
period, it will switch off automatic-
ally. You can change the duration
in the basic settings.
¡ For technical reasons steam can
escape from the appliance.
¡ If you press a button, a signal tone
sounds. You can deactivate the
signal tone in the basic settings.
Tip:Check and set the water hard-
ness before using your appliance.
Note
The first beverage will not yet have its
full aroma if:
¡ You are using the appliance for the
first time.
¡ You have run a service pro-
gramme.
¡ You have not used the appliance
for a long time.
Do not drink the beverage.
Tip:You will get a stable, fine-pored
crema after you have started up your
appliance and dispensed a few cups.
6.4 Water filter
1
You can use a water filter to minimise
limescale deposits and reduce impur-
ities in the water.
Inserting or replacing a water filter
If you have to change the inserted
water filter, lights up on the dis-
play.
ATTENTION!
Possible damage to the appliance
due to limescale build-up.
▶ Change the water filter in good
time.
▶ Change the water filter after
2months at the latest.
▶ Observe the display messages.
Requirement:The appliance is
switched on.
1. Press and hold buttons and
simultaneously for at
least 3 seconds.
2. Press button until the
display shows "W. hardness".
3. Confirm with "ok" button
.
4. Press button until the
display shows "Water filter".
5. Confirm with "ok" button
.
a The display shows "Filter act.".
6. Immerse the water filter in a glass
of water with the opening facing up
and press the sides together lightly
until no more air bubbles rise to
the surface.
→Fig. 7
1
Depending on the appliance specifications
To Next Page
Loading...
