Cleaning and servicing en
53
11.6 Cleaning the brewing
unit
In addition to automatic rinsing, also
remove and clean the brewing unit
regularly. Follow the illustrated in-
structions at the beginning of the
manual.
WARNING
Risk of burns!
Some parts of the appliance become
very hot.
▶ Never touch hot appliance parts.
▶ Allow hot appliance parts to cool
down before touching.
ATTENTION!
The brewing unit may be damaged
by improper cleaning.
▶ Do not use washing-up liquid.
▶ Do not use cleaning agents con-
taining vinegar or acids.
▶ Do not clean in the dishwasher.
→Fig. 17 - 26
Note:The door can only be closed if
the brewing unit and drip tray are in-
serted correctly.
11.7 Service programmes
The button lights up and
the display shows "Calc'nClean re-
quired!" depending on the water
hardness and use of your appliance.
Use the programme to descale and
clean your appliance.
ATTENTION!
Improper cleaning and descaling or a
delay in doing so may damage the
appliance.
▶ Perform Calc'nClean according to
the instructions immediately.
▶ Only put cleaning tablets in the
duct of the brewing unit.
▶ Do not put descaling tablets or
other products in the duct of the
brewing unit.
Notes
¡ If you do not descale and clean
the appliance in good time, the ap-
pliance is locked and the display
shows "Device locked".
¡ To unlock the appliance, run the
service programme.
Tip:Before you start the service pro-
gramme, remove, clean and re-insert
the brewing unit. Clean the milk
frother.
Start Calc'nClean
The process takes approx.40
minutes.
1. Press and hold the but-
ton for at least 5 seconds.
a symbol lights up.
2. Open the door.
3. Remove and empty the drip tray
and coffee dregs container.
4. Remove and clean the brewing
unit.
5. Put a cleaning tablet into the duct
of the brewing unit and re-insert
the brewing unit.
6. Insert the drip tray and coffee
dregs container again and close
the door.
a symbol lights up.
7. If there is a water filter, remove it.
To Next Page
Loading...
