Siemens EQ500 classic connect TP516DX3 - General Information; Basic Operation; Switching the Appliance on or off

operation en
53
2. Press or until the display
shows the desired language.
3. Press ⁠.
4. Determine the water hardness.
5. Press ⁠.
6. To set the water hardness, press
or ⁠.
7. Press ⁠.
8. Clean and fill the water tank.
9. Press ⁠.
10.For more information scan the QR
code
1
.
11.To now insert a water filter now,
press ⁠.
12.To insert a water filter later on,
press ⁠.
13.Fill the bean container.
14.Press ⁠.
15.Press ⁠.
a The appliance is rinsing and is
ready to use.
Tip:You can change the settings at
any time.
→"Overview of the basic settings",
Page61
7.5 General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Notes
¡ The appliance has been pro-
grammed at the factory with stand-
ard settings for optimum operation.
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can adjust the grinding level
when the grinder is running.
→"Adjusting the grinding level",
Page57
¡ During operation water droplets
may form at the ventilation slits
and on the lid of the tablet com-
partment.
¡ If you do not perform any actions
on the appliance for a certain
period, it will switch off automatic-
ally. You can change the duration
in the basic settings. →Page61
¡ For technical reasons steam can
escape from the appliance.
¡ The first beverage will not yet have
its full aroma if:
– You are using the appliance for
the first time.
– You have run a service pro-
gramme.
– You have not used the appli-
ance for a long time.
Do not drink the beverage.
Tip:You will get a stable, fine-pored
crema after you have started up your
appliance and dispensed a few cups.
operation
8 Basic operation
operation
8.1 Switching the appliance
on or off
▶
Switch the appliance on or off with
⁠.
1
Depending on the appliance specifications