Siemens EQ900 TQ903 Series - Remote Diagnostics; Data Protection Information

en HomeConnect
56
You can find the HomeConnect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
HomeConnect has been set up and
whether the appliance is connected
to your home network.
Overview of the Home Connect settings
Here you can find an overview of the "Home Connect" settings and network set-
tings.
Basic setting Selection Description
WiFi connection On
Off
Switch off the wireless module during
long absences or to save energy.
Note:In networked standby mode
your appliance requires max. 2W.
Remote start On
Off
Switch remote start on the appliance
on and off.
Note:With the "Home Connect" app
only switch-off is possible.
Add mobile
device
- Connect the appliance to the "Home
Connect" app or additional accounts.
Network informa-
tion
- Display network information and appli-
ance information.
Delete - Note:You cannot operate your appli-
ance via the "Home Connect" app
without a network connection.
Software update - Note:This setting is only available
with a software update.
11.3 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the HomeCon-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip:For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com
11.4 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the HomeConnect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).