What to do if my Siemens Cordless Telephone has no radio connection and all displays are flashing?
If your Siemens Cordless Telephone shows all displays flashing, indicating no radio connection to the base station, the issue might be due to several reasons: * You may be too far from the base station. Try moving closer. * The handset might not be registered. * The base station could be off. Check the power connector at the base station.
Why is there no display on my Siemens Gigaset 4015?
If there is no display on your Siemens Cordless Telephone, it could be due to the following reasons: * The handset may not be turned on. To resolve this, hold down the end call key for 1 second. * The batteries may be empty. In this case, charge or replace the batteries.
What to do if Siemens Gigaset 4015 generates error beep?
If your Siemens Cordless Telephone is generating an error beep (descending tone sequence), it indicates a wrong input. Repeat the procedure, carefully noting the display.
Why does the Siemens Gigaset 4015 Cordless Telephone answering machine announce 'PIN is incorrect'?
If the answering machine on your Siemens Cordless Telephone announces 'PIN is incorrect' during remote operation, it means that the system PIN entered is incorrect. Re-enter the system PIN.
Why does my Siemens Cordless Telephone answering machine message not have a time stamp?
If an answering machine message on your Siemens Cordless Telephone does not have a time stamp, it is because the date/time has not been set.
Why can't my caller hear me on my Siemens Cordless Telephone?
If your caller can't hear you when using the Siemens Cordless Telephone, it might be because the INT key was accidentally pressed, which mutes the microphone. To fix this, press the GO BACK OK key to reactivate the microphone.
What to do if my Siemens Cordless Telephone does not ring?
If your Siemens Cordless Telephone isn't ringing, the ringer might be turned off. You need to activate the ringer.
What to do if my Siemens Cordless Telephone has no reaction to keystroke?
If your Siemens Cordless Telephone doesn't react when you press a key, it's possible that the keypad protection is activated. To deactivate it, hold down the key for one second.
Why is my Siemens Gigaset 4015 Cordless Telephone flashing and has no radio connection?
If your Siemens Cordless Telephone shows all displays flashing and has no radio connection to the base station, there are several possible causes: * The handset might be out of the base station's range, so move closer. * The handset might not be registered; you need to register the handset. * The base station might not be activated; check the connector at the base station.
General| Type | Cordless Telephone |
|---|---|
| Phonebook entries | 20 |
| Talk time | 10 hours |
| Standby time | 100 hours |
| Caller ID | Yes |
| Redial | Yes |
| Handset Speakerphone | No |
| Base Speakerphone | No |
| Answering Machine | No |
| Headset Jack | No |
| Color Options | Black |
| Frequency | 1.8 GHz - 1.9 GHz (DECT) |
| Range | Up to 300 meters outdoors |
| Intercom | Yes |
To Next Page
