To Next PageTo Next PageWhy is there no display on my Siemens Cordless Telephone?
If your Siemens Cordless Telephone display is blank, it could be due to two reasons. First, the handset might not be activated; try holding down the end call key for one second. Second, the batteries might be empty; in that case, you should charge or replace the batteries.
What to do if my Siemens Cordless Telephone has no radio connection to the base station?
If your Siemens Cordless Telephone shows no radio connection to the base station (e.g., base station 1 is flashing), there are several possible causes: * The handset may be out of range; try moving closer to the base station. * The handset may not be registered; you should register the handset. * The base station may not be activated; check the connector at the base station.
Why is the caller ID not showing on my Siemens Cordless Telephone?
If the incoming call number is not displayed on your Siemens Cordless Telephone, even though Caller ID is set, it's likely that the caller has blocked the transmission of their telephone number. Callers must permit the transmission of their telephone numbers at their network provider.
What does the error beep mean on my Siemens Cordless Telephone?
If your Siemens Cordless Telephone is generating an error beep (descending tone sequence), it indicates a wrong input. Repeat the procedure, pay attention to the display, and refer to the operating instructions if necessary.
General| Brand | Siemens |
|---|---|
| Model | Gigaset 4210 |
| Category | Cordless Telephone |
| Language | English |
