Customer Care: 1-888-777-0211 or visit our Website: www.icm.siemens.com
Visite nuestro sitio Web para obtener instrucciones en español.
IMPORTANT: For best reception, place the base in a high central
location, away from other electrical devices. The installation of
the base unit should allow at least 8-inches between the base and
persons to be in compliance with FCC RF exposure guidelines.
STEP 1
Base Station Setup
At the Base Station:
1 Insert small plug on cord into phone
jack. Place cord in base cable
channel. Insert power supply unit
into wall outlet.
2 Insert plug on telephone cord into
telephone jack on base unit (clicks
into place). Place cord in cable
channel on bottom of base. Insert
other end of plug into telephone
jack on wall.
Bottom view of base
Page/
Registration
button
STEP 2
Handset Setup / Registration
IMPORTANT: Charge batteries 12 to 14 hours before using the
handset for the first time.
+
+
–
–
At the Handset:
1 Remove protective plastic film from display.
2 Insert batteries as shown.
Telephone
jack and
cord
Power
supply unit
and cord
110 VAC
60 Hz
4 Be sure power
supply is
plugged into
wall outlet.
3 Place battery cover on back of handset
and push gently upward until it clicks into
place.
5 For auto registration
to base, press and
hold the END key to
turn handset off and
place in base station
with display facing
out for 1 minute.
To Next Page
Loading...
