Siemens Gigaset C 450 - Operating the Base Station on; The PABX; Dialling Modes and Flash Time; Setting Pauses

25
Operating the base station on the PABX
Gigaset C 450 / en-AUS / A31008-M1706-C401-1-7619 / settings_bs_hs_pabx.fm / 8.8.06
Operating the base station on
the PABX
The following settings are only needed when
your PABX requires them. Please refer to the
user guide for your PABX.
You cannot send or receive SMS messages on
PABXs that do not support Calling Line Identifi-
cation.
Dialling modes and flash time
Changing the dialling mode
You can set the dialling mode.
§Menu§ 4IO11
~Q
§OK§ Touch tone dialling (DTMF).
a Press and hold (idle status).
Setting the flash time
You can set the flash time.
§Menu§ 4IO12
~
Enter digits for the flash time and
press
§OK§.
Q =80ms; 1 =100ms; 2 = 120 ms;
3 = 180 ms; 4 =250ms;
5 =300ms;
L = 600 ms; M = 800 ms
a Press and hold (idle status).
Setting pauses
Changing pause after line seizure
You can set the length of the pause inserted
between pressing the talk key
c and sending
the phone number.
§Menu§ 4IO1O
~ Enter digit for the pause length
(1 =1 sec.; 2 =3sec.; 3 =7sec.)
and press
§OK§.
a Press and hold (idle status).
Changing the pause after the recall key
You can change the length of the pause if your
PABX requires this (refer to the user guide for
your PABX).
§Menu§ 4IO14
~ Enter a digit for the length of the
pause (1 =800ms; 2 = 1600 ms;
3 = 3200 ms) and press
§OK§.
a Press and hold (idle status).
Switching temporarily to
tone dialling (DTMF)
If your PABX still operates with dial pulsing (DP),
but you need tone dialling (DTMF) for a connec-
tion (e.g. to listen to the network mailbox) you
must switch to tone dialling for the call.
Requirement: You are conducting a call or
have already dialled an external number.
+ Press the star key. Tone dialling is
now activated for this call only.