33
Handset settings
Gigaset C350 / GBR / A31008-M1621-L161-1-7619 / settings_bs_hs.fm / 19.1.05
Changing ringer tones
u Volume:
You can choose between five volumes
(1–5; e.g. volume 2 = ˆ) and the
"crescendo" ring (6; volume increases
with each ring = ‰ ).
u Melody:
You can select a melody from the list of
pre-loaded ringer melodies, or you can
download a melody or install one by
SMS (page 23). The first three melodies
are the "classical" ring tones.
You can also set different melodies for the
following functions:
u External Calls: For external calls
u Internal Calls: For internal calls
Setting ringer volume
The ringer volume is the same for all types
of ring.
With the handset in idle status, open the
menu Ringer Volume by pressing t
briefly.
§Menu§ ¢ Audio Settings ¢ Ringer Volume
q Adjust the volume and
press
§OK§.
a Press and hold (idle status).
Setting ringer melody
Set different ringer melodies for external
and internal calls.
§Menu§ ¢ Audio Settings ¢ Ringer Melody
Select External Calls / Internal
Calls and press
§OK§.
q Select melody (‰ =on) and
press
§OK§.
a Press and hold (idle status).
Activating/deactivating the ringer
You can turn off the ringer on your hand-
set before you take a call or while the
phone is in the idle state. The ringer can-
not be re-activated while an external call is
in progress.
Deactivating the ringer
P Press the star key and hold
until you can no longer hear
the ringer tone.
Re-activating the ringer
P Press the star key and hold.
Activating/deactivating
suppression of the first ring tone
The phone identifies an incoming SMS
from the first network signal.
§Menu§ 54O1O
1 §OK§ To suppress the first ring tone.
Or:
S §OK§ To hear the first ring tone.
Please note:
If first ringer tone suppression is deacti-
vated, then every incoming SMS will be
signalled by a ring tone. If you take this
type of "call" at the first ring tone, you will
lose the SMS.
To Next Page
Loading...
