26
Using the directory and lists
Gigaset C380-C385 / IM English / A31008-M2007-R101-2-3T19 / direct_charges.fm / 09.11.2010
Version 4, 16.09.2005
The following functions can be selected with
q:
Use Number
Save or modify a saved number and then
dial with c or save as a new entry; to do
so, press
§Menu§ ¤ Copy to Directory ¤ §OK§
after the number appears on the display.
Delete Entry
Delete selected entry.
Send Entry
Send a single entry to a handset
(¢ page 26).
Delete List
Delete all directory entries.
Send List
Send complete list to a handset
(¢ page 26).
Shortcut
Assign the current entry for speed dial to
a selected key.
Using speed dial keys
You can assign directory entries to the keys 0
and 2-9:
s ¤ q (select entry) ¤
§Menu§ ¤ Shortcut
¤ ~ (press the key you want to assign the
number to)
To dial, press and hold the required speed
dial key.
Sending the directory to another
handset
Preconditions:
u The sending and receiving handsets must
both be registered to the same base sta-
tion.
u The other handset and the base station
can send and receive directory entries.
s ¤ q (select entry) ¤
§Menu§(open menu)
¤ Send Entry / Send List
~ Enter the internal number of the
receiving handset and press
§OK§.
Successful transmission is acknowledged
with the message Entry copied. . You can
transfer several individual entries one after
the other by responding
§OK§ to the Next
entry? prompt.
Please note:
u Entries with identical numbers are not
overwritten on the receiving handset.
u The transfer is cancelled if the phone
rings or if the memory of the receiving
handset is full.
Copying a displayed number to the
directory
You can copy numbers displayed in a list, e.g.
the calls list or redial list, to the directory.
A number is displayed:
§Menu§ ¤ Copy to Directory
¤ Complete the entry ¢ page 25.
Gigaset C385: The message playback is inter-
rupted during the number transfer from the
answer machine list.
Using a number from the directory
In some operating situations you can open
the directory to copy a number, for example.
Your handset need not be in idle status.
s Open the directory.
q Select entry.
§OK§ Press the display key.
Select function with q.
To Next Page
Loading...
