69
SMS (text messages)
SMS on a PABX
Gigaset C470-C475 IP / GBR / A31008-M1916-L101-1-7619 / sms_BRD_neutral.fm / 7.2.08
Version 2.1, 08.01.2007
Sending an SMS through another SMS centre
¤ Activate the SMS centre (2 to 4) as the active send service centre.
¤ Send the SMS.
This setting only applies to the next SMS to be sent. Thereafter, the setting returns to
Service Centr. 1.
SMS on a PABX
u You can only receive an SMS when the Calling Line Identification is forwarded to the
extension of the PABX (CLIP). The CLIP evaluation of the phone number for the SMS cen-
tre takes place in your Gigaset.
u If required, you must prefix the number for the SMS centre with the access code
(depending on your PABX).
If in doubt, test your PABX, e.g. by sending an SMS to your own number: once with and
once without the access code.
u When you send SMS messages, your sender number may be sent without your exten-
sion number. In this case the recipient cannot reply to you directly.
Sending and receiving SMS messages on ISDN PABXs is only possible via the MSN number
assigned to your base station.
Activating/deactivating SMS function
If you deactivate the SMS function, you cannot send or receive any SMS messages with
your phone.
The settings you have made for sending and receiving SMS messages (e.g. the call num-
bers of the SMS centres) and the entries in the incoming and draft message lists are saved
even after you turn off your phone.
v Open menu.
55O2L
Enter the digits.
Q
§OK§ Deactivate SMS function.
Or:
§OK§ Activate SMS function (default setting).
SMS troubleshooting
Error codes when sending
E0 Calling Line Identification permanently withheld (CLIR) or Calling Line Identification not activated.
FE Error occurred during SMS transfer.
FD Connection to SMS centre failed; see self-help.
To Next Page
Loading...
