Siemens Gigaset DX800A all in one - Saving Settings on the Phone

29
Gigaset DX800A all in one / UK / A31008-N3100-L101-2-7643 / web_server.fm / 28.3.11
Version 6, 21.08.2008
Outbound proxy mode
Specify when the outbound proxy should be used.
Always
All signalling and voice data sent by the phone is sent to the outbound proxy.
Automatic
Data sent by the phone is only sent to the outbound proxy when the phone is
connected to a router with symmetric NAT or a blocking firewall. If the phone is
behind an asymmetric NAT, the STUN server is used.
If you have set STUN enabled = No or have not entered a STUN server, the out-
bound proxy is always used.
Never
The outbound proxy is not used.
If you do not make an entry in the Outbound server address field, the phone
behaves independently of the selected mode, as with Never.
Outbound server address
Enter the (fully qualified) DNS name or the IP address of your provider's out-
bound proxy (maximum 74 characters).
Outbound proxy port
Enter the number of the communication port used by the outbound proxy.
The default port is 5060.
Saving settings on the phone
¤ Select Set to save the changes.
The Connections list is displayed after saving.
Or:
¤ Click the Cancel button to reject the changes you have made.
Or:
¤ Click the Delete Connection button to delete the VoIP connection from the con-
figuration. You can no longer be contacted via this phone number or make calls
via this connection.
If the connection you have deleted was the send connection of an internal sub-
scriber then a new send connection will automatically be assigned to this inter-
nal subscriber. This is the MSN with the lowest position number if the phone is
connected to the ISDN, or the fixed line network number if the phone is con-
nected to the analogue fixed line network.
Please note
With many providers, the outbound proxy is identical to the SIP proxy.