58
Base station settings
Gigaset S680/S685 / IM En / A31008-M1901-R101-1-3T19 / registr_sett.fm / 26.9.08
Version 4, 16.09.2005
Resetting the system PIN
If you have forgotten your system PIN you
can reset the base station to the original
code 0000:
Disconnect the power cord from the base
station. Hold down the registration/pag-
ing key on the base station while recon-
necting the power cable to the base sta-
tion. Release the key after a while.
The base has now been reset and the sys-
tem PIN 0000 set.
Changing ringer tones
(Gigaset S685 only)
u Volume:
You can choose between five volumes
and the "crescendo" ring, see page 50.
Select "0" to deactivate the base station
ringer tone.
u Ringer tones:
You can set a ringer tone melody for
external calls, see page 50.
v ¢ Ð ¢ Base ¢ Ringer Settings
For how to adjust the settings, see
page 50.
Activating/deactivating
music on hold
v ¢ Ð ¢ Base ¢ Music on hold
Press §OK§ to activate or deactivate music
on hold ( = on).
Repeater support
With a repeater you can increase the range
and reception strength of your base sta-
tion. You will need to activate repeater
mode. This will terminate any calls that
are in progress at the time.
Precondition: A repeater is registered.
Eco mode is disabled.
v
¢ Ð ¢ Base ¢ Add. Features
¢ Repeater Mode
§Yes§ Press the display key.
When repeater mode is active, the menu
item is marked with .
Restoring the base station to
the factory settings
When the settings are restored
u eco mode is disabled,
u handsets are still registered,
u the system PIN is not reset.
v
¢ Ð ¢ Base ¢ Base Reset
~ Enter the system PIN and press
§OK§.
§Yes§ Press the display key.
Cancel the restoring process by pressing
a or the display key
§No§.
a Press and hold (idle status)
Please note:
All handsets are deregistered and must be re-
registered.
Please note:
Repeater support and eco mode (see page 13)
rule each other out, i.e. both functions cannot
be used at the same time.
To Next Page
Loading...
