EasyManua.ls Logo

Siemens Gigaset S685 - Initial Setup and Configuration; Connecting and Powering Up

Siemens Gigaset S685
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
First steps
Gigaset S680/S685 / IM En / A31008-M1901-R101-1-3T19 / starting.fm / 26.9.08
Version 4, 16.09.2005
Range and reception strength
Range:
u Outdoors: up to 300 m
u Indoors: up to 50 m
The range is reduced when eco mode is
activated (see page 13).
Reception strength:
The display shows the quality of the radio
range between the base station and hand-
set:
u Good to poor: ÐiÑÒ
u No reception: | flashes
Connecting the base station
¤ First connect the power supply unit
and then the phone jack as shown
below and place the cables in the cable
recesses.
1 Mains adapter 230 V
2 Phone jack with phone cord
Please note:
u The mains adapter must always be
connected, as the phone will not oper-
ate without mains connection.
u Only use the mains adapter and phone
cord supplied.
u If you buy a replacement phone cord,
make sure that the phone jack has the
correct type of wiring.
Setting up the handset for use
The display is protected
by a plastic film.
Please remove the
protective film!
Inserting the batteries
¤ Insert the batteries the right way round
(see figure).
2
1
1
Gigaset S680
2
1
1
Gigaset S685
Correct phone jack assignment
1unused
2unused
3a
4b
5unused
6unused
Warning:
Use only the rechargeable batteries recom-
mended by Gigaset Communications GmbH *
(page 64). Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
3
2
1
4
5
6

Table of Contents

Related product manuals