70
Setting the base
Gigaset SL400 / EN for Greek / A31008-M2103-T101-1-8U19 / registr_sett.fm / 08.03.2010
Version 4, 16.09.2005
Setting the base
The base settings are changed using a regis-
tered Gigaset handset.
Activating/deactivating
music on hold
v ¢
Ï
¢ Audio Settings
¢ Music on hold
Press §Change§ to activate or deactivate the
music on hold (³ = on).
Activating repeater
support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
v
¢
Ï
¢ System ¢ Repeater Mode
Press §Change§ to activate/deactivate repeater
mode (³ = activated).
Switch your handset off and on again
(
¢ page 22), once the repeater has
been activated/deactivated.
Protecting against
unauthorised access
Protect the system settings of the base with
a PIN known only to you. The system PIN
must be entered when, for example, regis-
tering/de-registering a handset to/from the
base or when restoring the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only to you.
v
¢
Ï
¢ System ¢ System PIN
~ Enter the current system PIN
and press
§OK§.
~ Enter your new system PIN and
press
§OK§.
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the base to the original code 0000:
Disconnect the power cable from the base.
Hold down the registration/paging button
on the base while reconnecting the power
cable to the base. Hold down the button for
at least 5 seconds.
The base has now been reset and the system
PIN is set to 0000.
Please note
u Eco Mode / Eco Mode+ (¢page 52)
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
Please note
All handsets are de-registered and must
be re-registered. All settings are reset to
the default settings.
To Next Page
Loading...
