Siemens Gigaset SL400 - Setting Pauses; Switching Temporarily to Tone Dialling (DTMF)

73
Connecting the base to the PABX
Gigaset SL400 / EN for Greek / A31008-M2103-T101-1-8U19 / pabx.fm / 08.03.2010
Version 4, 16.09.2005
Setting pauses
Changing the pause after line
seizure
You can change the length of the pause that
is inserted between pressing the talk key
c and sending the number.
v Open the main menu.
*#Q5#L
Press keys.
~ Enter number for the length of
the pause (1 = 1 sec.; 2 = 3 secs.;
3 = 7 secs.) and press
§OK§.
Changing the pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v Open the main menu.
*#Q5#2
Press keys.
~ Enter a number for the length of
the pause (1 = 800 ms;
2 = 1600 ms; 3 =3200ms) and
press
§OK§.
Changing a dialling pause (pause
after access code)
Prerequisite: You have saved an access code
(
¢ page 72).
v Open the main menu.
*#Q5#
Press keys.
~ Enter number for the length of
the pause
(1 = 1 sec.; 2 = 2 secs.;
3 = 3 secs.; 4 =6secs.)
and press
§OK§.
To insert a dialling pause: press and hold
S for 2 seconds. A P appears in the dis-
play.
Switching temporarily to
tone dialling (DTMF)
If your PABX still operates with pulse dialling
(PD), but you need tone dialling for a con-
nection (e.g., to listen to the network mail-
box), you must switch to tone dialling for the
call.
Prerequisite: You are conducting a call or
have already dialled an external number.
* Press the star key.
After the call ends, pulse dialling is automat-
ically activated again.