13
Basic settings
Your appliance has various Basic settings, which are preset at
the factory. You can, however, change these basic settings as
required.
If you want to cancel all the changes, you can restore the
factory settings.
1. If required, turn the operating mode selector to Û to switch off
the appliance.
2. Press and hold the 0 button until ™‹ ƒ appears in the
display.
3. Press the 0 button until the desired basic setting appears.
4. Press the A or @ button to change the basic setting.
5. Press and hold the 0 button to exit basic settings.
The change is saved.
You can change the following basic settings:
Automatic safety cut-out
If you do not change the settings on your appliance for several
hours, the automatic safety switch-off function will be activated.
”‰ appears in the display.
Press any button to deactivate the automatic safety switch-off.
You can now make new settings.
Care and cleaning
In this section, you will find information on
■ care and cleaning of your appliance
■ the cleaning aid
■ descaling
: Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
■ harsh or abrasive cleaning agents
■ oven cleaners
■ corrosive or aggressive cleaners, or those containing
chlorine
■ cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Caution!
Risk of surface damage: If descaler or the oven and grill
cleaning gel comes into contact with the front of the appliance
or other sensitive surfaces, wash it off immediately with water.
Remove food residues from the cooking compartment as soon
as the appliance has cooled. Burnt-on remains will be much
harder to remove later.
For heavy soiling use the cleaning aid (see section: Cleaning
aid).
Basic setting Function Possible settings
™‹ ƒ
Display brightness
™‹ ‚ = dark
™‹ ƒ = medium
™‹ „ = bright
™‚ ƒ
Signal duration:
Sets the length of the audible signal at the end of an opera-
tion
™‚ ‚ = short (10 seconds)
™‚ ƒ = medium (2 minutes)
™‚ „ = long (5 minutes)
™ƒ ‚
Display the clock when the appliance is off
™ƒ ‹ = off
™ƒ ‚ = on
™„ ‚
Continue after the door is closed. Not necessary to restart
after the door has been opened
™„ ‹ = off
™„ ‚ = on
™… ƒ
Time until changes are automatically saved
™… ‚ = short (2 seconds)
™… ƒ = medium (5 seconds)
™… „ = long (10 seconds)
™† ƒ
Sets the water hardness range for the descaling indicator
™† ‹ = softened
™† ‚ = soft (I)
™† ƒ = medium (II)
™† „ = hard (III)
™† … = very hard (IV)
™‡ ‹
Steam cooking heat signal
™‡ ‹ = off
™‡ ‚ = on
™ˆ ‹
Restore the appliance to the factory settings:
■ all changes to the basic settings are cleared
■ Automatic calibration is carried out again
™ˆ ‹ = do not restore
™ˆ ‚= restore
To Next Page
Loading...
Need help?
General