Siemens HiPath 1100 V7.0 - Installing a CTR- UP0;E Module

Installation
3-26 HiPath1120, Installation Guide
Installing modules
3.7.9 Installing a CTR- U
P0/E
module
Installation Procedures
Assembly Diagram
Figure 3-11 Installing a CTR- U
P0/E
HiPath 1120 module
The line length of the analog stations is restricted to 100m when using comfort
telephones.
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Attach the module to the corresponding Connector on the MB
4. Reassemble the entire set.
5. “Performing a visual inspection” on page 3-35.
6. Turn on the power supply.
7. Configure the required data (see Service Manual).