Installation
3-28 HiPath1120, Installation Guide
Installing the power supply
3.8 Installing the power supply
Introduction
3.8.1 On the HiPath 1120
Installation Procedures
Figure 3-13 Installing a power supply on the HiPath 1120
Before connecting the power supply to the system, see Service Manual.
Step Procedure
1. Check network voltage
2. If the voltage is within the power supply’s voltage range, connect the power supply.
3. “Performing a visual inspection” on page 3-35
4. Configure the required data (see Service Manual).
Warning
Use the cable of the power supply to turn system power on or off.
!
To Next Page
Loading...
