Siemens iQ500 ET9 LMP1 Series - 13.2 Changing basic settings; 14 Cleaning and servicing; 14.1 Cleaning products; 14.2 Cleaning the glass ceramic

en Cleaning and servicing
12
Dis-
play
Selection
⁠ ⁠ Energy consumption display
Ask your electricity supplier what the mains
voltage is.
– Consumption display is switched off.
1
– Consumption display at mains voltage of
230V.
– Consumption display at mains voltage of
400V.
– Consumption display at mains voltage of
220V.
– Consumption display at mains voltage of
240V.
Automatic timer
- Switched off.
1
⁠- - Cooking time after which the hotplates
switch off.
Duration of the timer end signal
– 10seconds.
1
– 30seconds.
– 1minute.
⁠ ⁠ Activation of the heating elements
– Switched off
– Switched on
– The last setting before switching off the
hotplate.
1
Resetting to the factory settings
– Switched off.
1
– Switched on.
1
Factory setting
13.2 Changing basic settings
Requirement:The hob is switched off.
1.
Switch on the hob.
2.
Within the next 10seconds press and hold for
approx. 4seconds.
a appears.
a lights up on the hotplate display.
3.
Touch repeatedly until the required display ap-
pears.
4.
Set the required value on the control panel.
5.
Press and hold for 4seconds.
a The setting is activated.
Tip:To exit the basic settings without saving, switch off
the hob using . Switch the hob on again and reset.
Cleaning and servicing
14 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
14.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶ Never use unsuitable cleaning products.
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
14.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note:Note the information on unsuitable cleaning
products. →Page12
Requirement:The hob has cooled down.
1.
Remove heavy soiling using a glass scraper.
2.
Clean the hob with a cleaning product for glass
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip:You can achieve good cleaning results using a
special sponge for glass ceramic.
14.3 Cleaning the hob surround
Clean the hob frame after use if dirty or stained.
Notes
¡ Note the information on unsuitable cleaning
products. →Page12
¡ Do not use the glass scraper.