en Basic operation
16
Basic operation
Basic operation
Basic operation
You can find out everything you need
to know about operating your appli-
ance here.
Switching on the appliance
1. Press .
a The appliance begins to cool.
a A warning signal sounds and
lights up because the freezer com-
partment is still too warm.
2. Switch off the warning signal with
.
a goes out as soon as the set
temperature has been reached.
3. "Set the required temperature."
→Page16
Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
Switching off the appliance
▶
Press .
a The appliance stops cooling.
Setting the temperature
After you have switched on the appli-
ance, you can set the temperature.
Setting the freezer compartment
temperature
▶
Press / repeatedly until the
temperature display shows the re-
quired temperature.
The recommended temperature in
the freezer compartment is
−18°C.
Additional functions
Additional functions
Additional functions
Find out which additional functions
which can be used for your appli-
ance.
Automatic Super freezing
Automatic Super freezing automatic-
ally switches on when warm food is
placed in the freezer.
With automatic Super freezing, the
freezer compartment cools down to a
much lower temperature than for nor-
mal mode. This freezes food quickly
right through to the centre.
If the automatic Super freezing is
switched on, lights up and in-
creased noises may occur.
After operation, the appliance
switches from automatic Super freez-
ing to normal operation.
Cancelling automatic Super freezing
▶
Press .
a The previously set temperature is
displayed.
To Next Page
Loading...
