Rails en
27
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards .
21.3 Removing the pull-out rail
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→"Basic settings", Page17
¡ The pull-out rails can be installed at any level as re-
quired.
¡ If necessary, you can equip all levels with a pull-out
rail.
1.
Push on the side of the tab marked PUSH behind
the rail, and push the rail to the rear.
2.
Press and hold PUSH and swing the rail out-
wards until the front retainer is detached.
3.
Pull the rail out towards the front.
4.
Remove the pull-out rail.
5.
Clean the pull-out rail.
→"Cleaning products", Page19
Note:
Further information:
21.4 Attaching the pull-out rail
Note:The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer from
below behind the two guide rods for the required
shelf position and keep it horizontal.
To Next Page
Loading...
