en Noise
48
> Noises
No i s e
Normal noises
Droning: A motor is running, e.g. refrigerating unit, fan.
Bubbling, buzzing or gurgling: Refrigerant is flowing
through the tubes.
Clicking: Motor, switches or solenoid valves are
switching on and off.
Cracking: Automatic thawing successful.
Preventing noises
Appliance is not level: Align appliance using a spirit
level. If required, place a little packing underneath.
The appliance is not "free-standing": please move the
appliance away from adjacent furniture or appliances.
Containers, shelves or storage compartments wobble
or stick: Check the removable fittings and re-insert if
required.
Bottles or receptacles are touching each other: Move
bottles or receptacles away from each other.
3 Faults – what to do?
Fau l t s – wh a t to do?
Before you call customer service, use this table to check whether you can rectify the fault yourself.
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 38
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follo-
wing day.
Displays do not illuminate.
The mains plug has not been inserted properly. Connect the mains plug.
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
Display shows E....
Electronics have detected a fault. Call Customer Service.
~ "Customer service" on page 49
The alarm off button flashes and a warning signal sounds.
Press alarm off button. The alarm is switched off.
Refrigerator compartment, cool-fresh compartment or freezer com-
partment is open.
Close the appliance.
Ventilation openings are covered up. Clear the ventilation openings.
Large quantities of fresh food were placed in the appliance. Do not exceed maximum freezing capacity.
The temperature in the refrigerator compartment, cool-fresh compart-
ment or freezer compartment is too warm.
Press alarm off button. After the alarm off button is pressed, the war-
mest temperature reached in the freezer compartment is displayed
for 5 seconds. The display stops flashing.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on. Start the appliance self-test.
~ "Appliance self-test" on page 49
When the programme has ended, the appliance switches over
to normal operation.
To Next Page
Loading...
