Siemens Iq700 KF96D Series - Warning Signals and Alarms; Temperature Deviations; Water Leaking from Appliance

en Troubleshooting
36
Fault Cause and troubleshooting
A warning signal
sounds and "alarm"
flashes.
The door alarm is
switched on.
The appliance door is open.
▶ Close the appliance door.
A warning tone
sounds and the tem-
perature display
(freezer compartment)
and "alarm" flash.
The temperature
alarm is switched on.
Different causes are possible.
1. Press alarm.
a The alarm is switched off.
2. After several hours, check whether the set freezer
compartment temperature has been reached again.
External ventilation openings are covered up.
▶ Remove any obstructions from in front of the ex-
ternal ventilation openings.
Larger quantities of fresh food have been put in.
▶ Switch on Super freezing before placing a larger
amount of food in the appliance.
→"Switching on manual Super freezing", Page21
The temperature dis-
plays and "alarm" light
up.
A sensor is defective.
▶ Call customer service.
The customer service number can be found in the
enclosed customer service directory.
The temperature dif-
fers greatly from the
setting.
Different causes are possible.
1.
Switch off the appliance. →Page19
2. Switch the appliance back on after fiveminutes.
→Page18
‒ If the temperature is too warm, check the temper-
ature again after a couple of hours.
‒ If the temperature is too cold, check the temper-
ature again on the following day.
Water is leaking out of
the appliance.
The water connection or water hose is not leak-tight.
▶ Check if the water connections are fastened firmly
and the water hose is undamaged.
If necessary, replace the water hose.
The drip tray is overflowing.
▶
Clean the drip tray. →Page31