8/23
Building Technologies CC1N7101en
HVAC Products 29.06.2006
Ordering
Gas burner control, without plug-in base refer to «Type summary»
Connection accessories for small burner controls refer to Data Sheet N7201
- Plug-in base AGK11...
- Cable holders AGK65..., AGK66, AGK67...
- Cable strain relief elements for AGK67...
Connection accessories for small burner controls refer to Data Sheet N7203
- Plug-in base AGK13...
- Plug-in housing AGK56…
- Accessories AGK68…
Flame detectors
- Ionization probe supplied by thirds
- Flame detector QRA2... or QRA10... refer to Data Sheet N7712
- Blue-flame detector QRC1... refer to Data Sheet N7716
Diagnostics tool refer to Data Sheet N7614
- Interface adapter OCI400
- PC Windows software ACS400
Actuators SQN3... refer to Data Sheet N7808
Actuators SQN7... refer to Data Sheet N7804
Actuators SQN9... refer to Data Sheet N7806
RC unit ARC 4 668 9066 0
For the supervision of ionization currents in networks with nonearthed neutral conductor
PTC resistor (AC 230 V)
GK25
For producing a burden on terminal 3 (on burners with no fan motor, e.g. atmospheric
gas burners)
Ancillary unit for UV supervision
- Cable length 500 mm AGQ3.1A27
- Cable length 300 mm AGQ3.2A27
Can be fitted under the plug-in base (for size, refer to «Dimensions»)
Service adapter KF8872
- For checking the functioning of the burner controls on the burner plant
- Functional test with signal lamps
Note: With no load on the output terminals, the relevant signal lamp may light up.
- Detector resistance measurement with a jack of 4 mm diameter
To Next Page
Loading...
Need help?
General
