Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 30 of 64 15.11.2001
1.4.8 AT^SSTGI Remote-SAT Get Information – Send DTMF (20)
Write command
AT^SSTGI=20
This command is to be used upon receiving an unsolicited result code
^SSTN:20.
The SIM Application is sending DTMF tones to the network, and can provide the
TA with some information about this.
Text and an Icon Identifier can be passed to the TA to display to the user.
Response
^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>
<CR> <LF>
Parameters
<cmdType> 20 – Proactive command ID see Table 1
<commandDetails> This byte is RFU.
<text> String to provide user with information.
<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId> 0-255, 0: no icon
Reference
Siemens
Note
To Next Page
Loading...
Need help?
General
