Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 43 of 64 15.11.2001
1.5.2.3 AT^SSTR Remote-SAT Response – Setup Call (16)
Write command
AT^SSTR=16,
<status>
The TA indicates if the call setup has been accepted by the user.
For further details please refer to chapter “AT^SSTGI Remote-SAT Get
Information – Setup Call (16)”, pg. 25.
Response
After confirmation phase the TA may show a dialling animation on the screen
until a mandatory URC is issued.
^SSTR: 16, <TermQualifier>, <TerminationCauseText>
For a detailed explanation of these parameters please refer to chapter
“AT^SSTGI Remote-SAT Get Information – Setup Call (16)”, pg. 25.
OK
Parameters
<cmdType> 16 – Proactive command ID, see Table 1.
<status> Unsigned Integer, range 0-255
0 Command performed successfully
Indicate that the user has accepted the call request.
16 Proactive SIM session terminated by user
20 USSD/SS Transact terminated by user
32 TA currently unable to process command
132 TA currently unable to process command because
screen is busy.
34 User did not accept the proactive command.
Indicate that the user has denied the call request.
35 User cleared down call before connection or network
release
Reference
Siemens
Note
To Next Page
Loading...
Need help?
General
