Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 56 of 64 15.11.2001
1.5.3.3 AT^SSTR Remote-SAT Event Response – Idle Screen Available (233)
Write command
AT^SSTR=233
Sent by the customer application to indicate that the screen has become idle.
Response
OK
Parameters
<cmdType> 233 – Event command ID, see Table 1.
Reference
Siemens
Note
1.5.3.4 AT^SSTR Remote-SAT Event Response – Language Selection (235)
Write command
AT^SSTR=235, , ,
<inputString>
Sent by the customer application to indicate that the customer application
has changed language.
Response
OK
Parameters
<cmdType> 235 – Event command ID, see Table 1
<inputString> Two character language tag, e.g. “en” for English or
“de” for German, refer to appendix.
Reference
Siemens
Note
1.5.3.5 AT^SSTR Remote-SAT Event Response – Terminate Command (254)
Write command
AT^SSTR=254
This command allows the TA to finish an ongoing proactive command, if any.
This is done by sending a Terminal Response “ME currently unable to
process command - screen is busy” to the SIM (see table “Remote-SAT
Command Status”, pg. 41), if issued in states PAC or WAIT. No action is
performed if the interface is already in IDLE state. However, command
returns “OK”.
The actual reaction regarding the Terminal Response depends on the SIM
application.
The command can be used to return to IDLE state regardless whether a
Proactive command is ongoing or not.
Response
OK
Parameters
<cmdType> 254 – Event command ID, see Table 1
Reference
Siemens
Note
This command is allowed in states IDLE, PAC and WAIT and forces a return
to IDLE state once it has been issued successfully, i.e. OK response.
To Next Page
Loading...
Need help?
General
