7.2 SINUMERIK Integrate with HMI-Advanced
7.2.1 Installing SINUMERIK Integrate client
If the SINUMERIK Integrate Client has already been installed, this must first be uninstalled.
The procedure for installation for the first time is explained below.
Prerequisite
You installed Internet Explorer 6 or higher.
Procedure
1. Start the PCU in the Windows service mode.
2. Open the following directory: SI5\Clients\SinIntClient\HMI Advanced.
3. Copy the setup file into the installation directory on the PCU.
4. Start the "eps_client_AT.exe" setup file by double-clicking.
– If you have not installed the appropriate Internet Explorer, a corresponding message is
displayed. For example, the program requires Internet Explorer 6 or higher.
The installation is aborted and you must first install the appropriate Internet Explorer.
Then restart the client installation.
Installing SINUMERIK Integrate
7.2 SINUMERIK Integrate with HMI-Advanced
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
152 Installation Manual, 12/2019, A5E44672080B AE
To Next Page
Loading...
Need help?
General
