10.Select the connection type in the next window:
– "1:1"
The function allows a direct connection to a SINUMERIK controller.
– "1:N"
The function allows a connection in a group to several SINUMERIK controllers.
– "Flying HMI"
The function allows the use of SINUMERIK Integrate on a SINUMERIK controller on
which a client cannot be installed because the operating software does not support this
client. In this case, SINUMERIK Integrate is installed and configured on a workplace PC
or machine PC (IPC). PC/IPC and SINUMERIK controller communicate via a (W)LAN
connection.
Select connection type 1:1 and click "Next >".
Installing SINUMERIK Integrate
7.2 SINUMERIK Integrate with HMI-Advanced
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
156 Installation Manual, 12/2019, A5E44672080B AE
To Next Page
Loading...
Need help?
General
