Removing the client setup
1. In the "Welcome" window, select the "Remove" function if you want to remove the client
setup.
Click "Next >".
2. A prompt appears.
Confirm this message with "Yes" if an additional application is installed and you want to
uninstall this application.
3. You may be shown an additional confirmation prompt asking, for example, whether you wish
to uninstall the Service Mode Client application.
Click "Yes" to start this operation.
Installing SINUMERIK Integrate
7.2 SINUMERIK Integrate with HMI-Advanced
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE 173
To Next Page
Loading...
Need help?
General
