Siemens MILKPERFECT EQ-5 - Adjusting the grind settings

29
en
4. Pressandholdthestartbutton(10)
foratleast5seconds.Thesetnumber
ofLEDswilllightuptoindicatethat
theselectedwaterhardnesshasbeen
savedsuccessfully.
Important:Ifawaterlterisused(special
accessoryorderno.467873),proceedas
follows,see“Waterlter”onpage27.
Note:Ifnobuttonispressedwithin
90seconds,theapplianceswitchesto
standbymodewithoutsavingthenew
settings.Inthiscase,thepreviouslysaved
waterhardnesssettingisretained.
Automaticswitch-off
Hereyoucansettheperiodoftimeafter
whichtheapplianceshouldswitchoffauto
maticallyfollowingthelastdrinkpreparation.
Atimebetween15minutesand4hourscan
beset.Thedefaulttimeis1hour,butthis
canbeshortenedtosaveenergy.
1. Turntherotary
knob(13)toposition 
2. PressandholdbuttonsB(11)andA
(12)simultaneouslyforatleast5sec
onds.Thetimeafterwhichtheappliance
shouldswitchoffisindicatedbythe
numberofLEDsthatnowlightup.
3. Nowpressthestartbutton(10)repeat
edlyuntiltherequirednumberofLEDs
lightuptoindicatetheswitchofftime:
D=15minutes
DandE=30minutes
D,EandF=45minutes
D,E,FandG=1hour
D,E,F,GandH=2hours
D,E,F,G,HandI=4hours
4. Pressandholdthestartbutton(10)for
atleast5seconds.Thesetnumberof
LEDswilllightuptoindicatethatthe
selectedswitchofftimehasbeensaved
successfully.
Note:Ifnobuttonispressedwithin
90seconds,theapplianceswitchesto
standbymodewithoutsavingthenew
settings.Inthiscase,thepreviouslysaved
switchofftimeisretained.
Settingthebrewingtemperature
Thebrewingtemperaturecanalsobeset.
1. Turntherotary
knob(13)toposition 
2. PressandholdbuttonsB(11)and
A(12)foratleast5seconds.Theset
brewingtemperatureisindicatedbythe
numberofLEDsthatnowlightup.
3. Nowpressthestartbutton(10)repeat
edlyuntiltherequirednumberofLEDs
lightuptoindicatethetemperature:
LEDD=low
LEDDandE=medium
LEDD,E,andF=high
4. Pressandholdthestartbutton(10)for
atleast5seconds.Thesetnumberof
LEDswilllightuptoindicatethatthe
selectedtemperaturehasbeensaved
successfully.
Note:Ifnobuttonispressedwithin
90seconds,theapplianceswitchesto
standbymodewithoutsavingthenew
settings.Inthiscase,thepreviouslysaved
brewingtemperaturesettingisretained.
Adjustingthegrindsettings
Theselector(3)forgrindsettingadjuststhe
grindsettingsfromcoarsetone.
¡
Warning!
Adjustthegrindingunitonlywhileitisrun
ning!Otherwisetheappliancemaybedam
aged.Donotreachintothegrindingunit.