Siemens Mobile - Calling Functions; Dialing, Redialing, and Call Management

©
Siemens AG 2003, M:\Mobil\R65\CF62_TMO\en\sug\A65_Phone.fm
23Calling
VAR Language: en; VAR issue date: 040413
left page (23) of CF62 Leopard TMO SUG us, A31008-H6050-A40-1-4A19 (02.06.2004, 16:08)
Calling
Dialing with number keys
Open the clamshell to access the
keypad.
The phone must be switched on
(standby mode).
J
Enter number (always
with area code/interna-
tional dialing code).
§Clear§ A short press clears
the last digit, a long press
clears the entire phone
number.
A
Press the Call key. The dis-
played phone number is
dialed.
End call
B
Press the End key briefly.
Press this key even if the
person on the other end
has hung up first.
Set volume
G
Use the top part of the
navigation key to start
adjusting the volume.
Then press top/bottom to
adjust the volume as
required (only possible
during a conversation).
If a Car Kit is used, its volume setting
will not affect the usual setting on
the phone.
Redial
To redial numbers that were dialed
previously:
A
Press the Call key once.
I
Select the required phone
number from the list,
then to dial ...
A
Press ...
If the number is busy
Auto. redial
§Auto Dial§ Press. The phone number
is automatically dialed ten
times at increasing time
intervals.
Callback b
§Callback§ Press. Your phone rings
when the busy number is
free.
Reminder
§Prompt§ Press. A beep reminds you
to redial the displayed
phone number after
15 minutes.
International dialing codes
0
Hold down until a "+" is dis-
played.
§Country§ Press and select country.