Pre-installation Instructions
Multimobil 5C
Siemens Ltd. Med India Version 5.0 Page 9 of 11
Copyright © SIEMENS LTD. All rights reserved. For internal use only
Observe the following steps:
1) Remove the restraining strips by cutting it. Use a cutting plier for this purpose.
2) Start removing the wooden planks. For this purpose the service engineer should use
a claw hammer or nail pulling plier and preferably a crow bar.
3) First of all remove the top planks. Upon opening this plank you will be able to see the
unit inside. Ensure that the unit has not received any transit damages.
4) Now, remove the front and rear wall of the box one by one. The front wall is provided
with a ramp. Hence, place this plank carefully for pushing the unit out of the platform.
5) Now you will see three wooden blocks fixed across the unit for supporting the wall
and also to support the image intensifier and single tank. These are supporting
beams.
6) Loosen these blocks from one side and remove them gently. Now, remove the side
walls.
7) Care should be taken to see that the wooden planks or the nails do not damage the
unit.
8) Now, you can easily remove the ESD bags.
9) After removing the ESD bags, remove the monitor boxes and accessories and take
them to the OT.
10) Remove the packing strips and thermocol packing from the control, II and single
tank. Also, remove the wooden lever fixed at the base by cutting the strap.
11) Next step is to remove the clamping brackets. First of all, remove the bracket used
for clamping the single tank and Image intensifier. Secondly, remove the bracket
used to clamp C-arm. Third, remove the brackets on the rear wheels. Next remove
the brackets used to clamp the base.
12) Now ensure that the rear wheels are in locked condition. Also the C-Arm should be
in locked condition.
13) Remove the bolts of the clamping brackets at the rear side on which the housing is
resting. Now, using the lever, gently lift the base along the bracket so that the rubber
block can be removed. Once the rubber blocks are removed, remove the clamping
bracket.
14) Now, remove the two brackets on the front end of the base. Lift from sides using
wooden lever. Remove the rubber buffer and remove the bracket.
15) Now the unit will be resting on the wooden platform. Release the brakes and push
the unit down to the ground through the ramp.
To Next Page
Loading...
