Hardware Installation
39
Building Technologies 048_DMS_NK8000_ICC_MP4.40_A6V10062437_a_en.doc
Fire Safety & Security Products 06.2011
Fig. 24 Cabinet installation
The VAC power supply wires (1.5 mm
2
) should be connected as illustrated in 0.
Careful attention should be paid to the correct connections of Vac power lines.
Fig. 25 VAC power connection
Wires pass through 20mm (cut-out) holes* at the top of the cabinet (see Fig. 26),
and continu
e behind the cabinet to pass through the rear-side cavity to the en-
trance hole (see Fig. 27 and Fig. 28) where they should be anchored securely be-
fore bein
g connected to the screw terminators.
360 mm
415 mm
Input VAC
1.5 mm
2
wires
To Next Page
Loading...
