Siemens NK8237 MP4.81-02 - Page 72

9
Maintenance and diagnostics
The NW8204 diagnostic tool
72
Building Technologies
A6V10854379_a_en
CPS Fire Safety
25.01.2019
17
EV_EEPROM_NEW_DATE_TIME
Date and time changed over delta threshold
18
EV_EEPROM_RESET
Reset command
19
EV_EEPROM_EMERGENCY
Restart in emergency mode
20
EV_EEPROM_FTP_SESSION
FTP session opened
21
EV_EEPROM_CONFIG_CHANGE
Configuration file changed
22
EV_EEPROM_SW_CHANGE
Software version changed
23
EV_EEPROM_CPU_CHANGE
CPU changed
24
EV_EEPROM_ETH_PNP_UPDAT
E
Ethernet EEPROM update
25
EV_EEPROM_ETH_PNP_ERROR
Ethernet EEPROM update failed
34
EV_EEPROM_DLL_LOAD_FAILED
DLL load failure
35
EV_EEPROM_DLL_EXCLUDED
DLL excluded from round-robin schedule
36
EV_EEPROM_DLL_OVERRUN
DLL response time over threshold 1
37
EV_EEPROM_DLL_VER_ERR
DLL version error
38
EV_EEPROM_DLL_INIT_ERR
DLL initialization error
39
EV_EEPROM_DLL_OVERTIME
DLL response time over threshold 2
40
EV_EEPROM_DLL_TIMEOUT
DLL response time over threshold 3
41
EV_EEPROM_DLL_EVENT
DLL diagnostic event
42
EV_EEPROM_HW_MISMATCH
PIC24 microcontroller init detected a
hardware version different from version in
EEPROM
43
EV_EEPROM_PIC24_FLASH_FAI
LURE
PIC24 microcontroller init failed to write the
microcontroller flash memory
44
EV_EEPROM_PIC24_PROGRAM
MED
PIC24 microcontroller init wrote a new
firmware into the microcontroller flash
memory
45
EV_EEPROM_PIC24_WRONG_H
EX
PIC24 microcontroller init detected a wrong
firmware into the microcontroller
46
EV_EEPROM_HW_FAILURE
Unable to retrieve information from the
EEPROM or from the PIC24 microcontroller
47
EV_EEPROM_FOUND_USB
USB mass storage device plugged
48
EV_EEPROM_REMOVE_USB
USB mass storage device unplugged
49
EV_EEPROM_FOUND_SD
SD card plugged
50
EV_EEPROM_REMOVE_SD
SD card unplugged
EVENT.LOG
This file is present only after the EEPROM is full for the first time. It contains (up to)
the four most recent backups of the EEProm.LOG file.
Upload of diagnostic files
1. Select one or more of the following diagnostic files:
– DIAGNO.LOG
– EEProm.LOG
– EVENT.LOG
2. Click Upload File.