Siemens OP1S - Change Slave

OP1S Operator Control Panel
Siemens AG 477 459 4070 72 J AA-6R
SIMOVERT MASTERDRIVES Operating Instructions
23
4.2 Change slave
During bus operation, a specific slave can be selected via the OP1S with the "Change
slave" function without any re-plugging. Starting from the basic menu, the "Change slave"
function is selected with the "Lower"/"Raise" key and activated with "P". The user is then
requested to enter a slave address.
Ê
Ê
P
Ì
Ì
MotionControl
Download
Delete data
# Change slave
Change slave
Address:00
Example of activating the "Change
slave" function
After the slave address has been entered with "Raise"/"Lower" and confirmed with "P", a
change is made to the required slave and the display returns to the basic menu. If the
slave cannot be found, an error message is output.