Need help?Do you have a question about the Siemens RDG Series and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | RDG Series |
| Category | Thermostat |
| Language | English |
Guidance on selecting the appropriate thermostat based on application and requirements.
Overview of the RDG wall-mounted thermostat line, its features and product variants.
Detailed listing of RDG100, RDG100T, RDG100KN, RDG110, and RDG140 models.
Description of the RDF semi flush-mount thermostat range and its design.
Overview of stand-alone RDF and RDU thermostats, including timer and bus interface versions.
Covers various FCU systems like 2-pipe, 4-pipe, and 2-stage heating/cooling.
Details VAV applications including single-duct systems with or without electric heaters.
Applications for climate control in chilled/heated ceilings or radiator systems.
Covers heat pump systems with DX type equipment for heating or cooling.
Covers 2-pipe systems with ON/OFF or modulating control outputs for fan coil units.
Details applications for 2-pipe fan coil units incorporating an electric heater.
Guidance on setting up RDG and RDF room thermostats to meet customer needs.
Details on adjusting control parameters for optimal performance and functions.
Steps for selecting, wiring, installing, and powering up the thermostat.
Setting parameters like control sequence (P01) and other application-specific settings.
Configuring inputs (X1, X2, D1) for sensors, switches, and operating mode selection.
Selecting and configuring control output types (On/Off, PWM, 3-pos., DC 0-10V).
Options for selecting fan modes, speeds, and operation via control parameters.
Downloading parameters for communicating thermostats via ACS and ETS Service Tools.
Checking configuration and status using diagnostic parameters in expert level.
Information on installing and commissioning KNX thermostats with Synco 700/Synco living.
Tips for optimizing energy efficiency using thermostat features and settings.
To Next Page
