Siemens REV24RF Series

G2206
REV24RF..
RCR10/868
Installationsanleitung Installation instructions Instructions d’installation
Istruzioni di montaggio Montage instructie Instrucciones de montaje
Instruções de montagem Návod k montáži a uvední do provozu Telepítési leírás
Instrukcja montażu i uruchomienia Installationsanvisning Asennusohje
Installationsvejledning
tr
Kurulum talimatlari Οδηγίες εγκατάστασης
A
B
C
D
E
F
CE1G2206xx 13.12.2007 1/29

Siemens REV24RF Series Specifications

General

Display	LCD
Communication	Wireless
Wireless	Yes
Radio Frequency	868 MHz
Output Type	Relay
Input Type	Internal temperature sensor

Summary

Mounting notes REV24 RF.. and RCR10868

Placement of units

Details on where to place the REV24RF.. transmitter and RCR10/868 receiver units for optimal signal reception.

Checking the wiring

Instructions and notes regarding the electrical connections for the devices.

Notes

General important notes regarding installation and compliance with local regulations.

Commissioning RF set

Switching on the REV24 RF..

Steps to power on the REV24RF.. transmitter unit, including battery preparation.

Selecting the language

Procedure for choosing the user interface language on the REV24RF.. controller.

Mounting RCR10868 temporarily

Guidance on temporarily installing the RCR10/868 receiver to find the best reception location.

RCR10868 and REV24 RF..

Information on how the RCR10/868 and REV24RF.. units are supplied and connected.

Mounting and setting up the REV24 RF..

Instructions for mounting and positioning the REV24RF.. controller/transmitter unit.

Finding the best place for reception

Method for testing and determining the optimal location for radio signal reception.

Mounting the RCR10868 in its final place

Steps to permanently install the RCR10/868 receiver after finding the best location.

Configuration and function check REV24 RF..

Configuration

Overview of device configuration options, including DIP switches and expert settings.

DIP Switches

Detailed explanation of DIP switch functions for sensor calibration, setpoint limits, temperature display, control action, pump run, start control, mode, radio clock, and reset.

Expert Settings

Accessing and configuring advanced expert level settings, including language, time zone, and daylight saving.

Function Check

Procedures for checking device display, comfort mode, and relay response.