Siemens RUGGEDCOM RS900

Certification
6
The RUGGEDCOM RS900 device has been thoroughly tested to guarantee its
conformance with recognized standards and has received approval from recognized
regulatory agencies.
6.1 Approvals
This section details the standards to which the RUGGEDCOM RS900 complies.
6.1.1 CSA
This device meets the requirements of the following Canadian Standards Association
(CSA) standards under certificate 16.70065161:
• CAN/CSA-C22.2 No. 62368-1
Information Technology Equipment – Safety – Part 1: General Requirements (Bi-
National Standard, with UL 62368-1)
• UL 62368-1
Information Technology Equipment – Safety Part 1: General Requirements
• CAN/CSA-C22.2 No. 213-M1987
Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous
Locations
• CAN/CSA-C22.2 No. 60079-0:11
Explosive Atmospheres – Part 0: Equipment – General Requirements
• CAN/CSA-C22.2 No. 60079-15:12
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test
and Marking of Type of Protection "n" Electrical Apparatus
• UL 60079-0, Edition 6.0 (2013)
Explosive Atmospheres – Part 0: Equipment – General Requirements
• UL 60079-15, Edition 4.0 (2013)
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection "n"
• ANSI/ISA-12.12.01-2013
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class
III, Division 1 and 2 Hazardous (Classified) Locations
RUGGEDCOM RS900
Installation Manual, 12/2020, C79000-G8976-1024-12
29