To Next PageTo Next Page
Need help?Do you have a question about the Siemens CP 1542SP-1 and is the answer not in the manual?
General| Model | CP 1542SP-1 |
|---|---|
| Category | Network Router |
| Power Supply | 24 V DC |
| Weight | 500 g |
| Interfaces | Ethernet, Serial |
| Protection class | IP20 |
| Mounting Type | DIN Rail |
| Serial Interface | 1 x RS232/RS485 |
| Operating Temperature | 0°C to 60°C |
| Certifications | CE, UL |
| Protocol Support | TCP/IP, UDP, HTTP, HTTPS, SNMP |
Describes the intended communication tasks for each CP type.
Details supported communication protocols and functions like S7, OUC, HTTP/HTTPS.
Explains telecontrol protocols like TeleControl Basic, DNP3, IEC 60870-5-104.
Outlines security features such as firewall, VPN, and e-mail security.
Explains the meaning of the module's front panel LEDs.
Covers general safety, overvoltage protection, and hazardous area notes.
Details specific requirements for ATEX/IECEx and UL HazLoc environments.
Provides instructions for mounting and installing the CP.
Describes how to connect the power supply and other cables.
Offers best practices for securing the system against unauthorized access.
Outlines the steps for configuring the CP using STEP 7 software.
Covers IP configuration, IPv6 support, and time-of-day synchronization.
Details configuration for telecontrol protocols like DNP3, IEC, and TeleControl Basic.
Focuses on VPN setup, firewall rules, and certificate management.
Describes the software blocks used for Open User Communication.
